Filter
Top Products
Others
99
VQT1C39
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there
are no remaining folder numbers that can
be used. (P86)
Format the card after saving necessary
data on a PC etc. (P84)
If you execute [NO.RESET] in the [SETUP]
menu after formatting, the folder number is
reset to 100. (P22)
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable (DMC-LZ7)/video cable
(DMC-LZ6) is connected to the camera.
Press [MENU/SET] if you want to delete
this message at once.
• Select [TV ASPECT] in the [SETUP]
menu to change the TV aspect. (P22)
• This message also appears when the
USB connection cable is connected to the
camera only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P85, 88)
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you
change the mode dial to print mode [ ]
while this unit and the PC are connected. If
a printer is connected, change the mode to
a mode other than [ ] mode and then
check that no data is being transferred.
([ACCESS] appears on the LCD monitor of
this unit while data is being transferred.)
[USB MODE CHANGED. PLEASE
REMOVE THE USB CABLE.]
This message will be displayed if you
change the mode dial to a mode other than
print mode [ ] while this unit and the
printer are connected.
Set the mode dial to [ ] again and then
disconnect the USB connection cable. If
printing, stop the printing and then
disconnect the USB connection cable.
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P22)
∫ Batteries and the power source
1: The camera turns off immediately
even when battery power is full.
The remaining battery power is low
even if new batteries are inserted.
• The remaining battery power may not
be displayed accurately, and the
camera may suddenly stop working,
when the type of battery and the
settings on [BATTERY TYPE] are not
identical. However this is not a
malfunction. Depending on the battery
brand and the operating temperature, or
if exhausted batteries are used, the
remaining battery power may not be
displayed accurately.
– Please check [BATTERY TYPE] (P20)
in the [SETUP] menu.
2: The camera cannot be operated even
when it is turned on.
• Are the batteries inserted correctly?
• Use sufficiently charged batteries when
using Ni-MH batteries.
3: The LCD monitor turns off while the
camera is turned on.
• Is power save mode (P21) or economy
mode (P21) activated?
– Press the shutter button halfway to
cancel these modes.
• Are the batteries exhausted?
– Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
VQT1C39ENG.book 99 ページ ２００６年１２月２１日 木曜日 午前１０時５７分