Filter
Top Products
Connecting to other equipment
91
VQT1C39
∫ Layout printing
• When printing a picture several times
on 1 sheet of paper
For example, if you want to print the same
picture 4 times on 1 sheet of paper, set
[PAGE LAYOUT] to [ ] and then set
[NUM. OF PRINTS] to 4 for the picture
that you want to print.
• When printing different pictures on
1 sheet of paper
For example, if you want to print 4 different
pictures on 1 sheet of paper, set
[PAGE LAYOUT] to [ ] and then set
[COUNT] in [DPOF PRINT] (P78) to 1 for
each of the 4 pictures.
• Do not disconnect the USB connection
cable when the cable disconnection
warning icon [ ] is displayed.
(Depending on the printer, the icon may
not be displayed.)
• If the remaining battery power becomes
low while the camera and the printer are
connected, the status indicator blinks and
the alarm beeps. If this happens during
printing, press [MENU/SET] and stop
printing at once. If not printing, disconnect
the USB connection cable.
• The camera is receiving an error message
from the printer when the [¥] indication
lights orange during printing. After
finishing printing, make sure there are no
problems with the printer.
• If the total number of DPOF prints or the
number of DPOF pictures printed is high,
pictures may be printed several times. The
remaining number of prints indicated may
differ from the number set. This is not a
malfunction.
• With date printing, the setting on the
printer may take priority over the setting
on the camera. Check the date print
setting on the printer also.
• The message [USB MODE CHANGED.
PLEASE REMOVE THE USB CABLE.]
appears if you change the mode dial to a
mode other than [ ] while the camera
and the printer are connected. Set the
mode dial to [ ] again and then
disconnect the USB connection cable. If
this happens during printing, stop printing
and then disconnect the USB connection
cable.
VQT1C39ENG.book 91 ページ ２００６年１２月２１日 木曜日 午前１０時５７分