Filter
Top Products
VQT1X57
94
Advanced (Playback)
•Depending on the photo printing store or the printer, the date may not be printed even if you set
to print the date. For further information, ask at your photo printing store or refer to the
operating instructions for the printer.
•The date cannot be printed on pictures stamped with text.
Note
•
The number of prints can be set from 0 to 999.
•With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
•It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
•If the file is not based on the DCF standard, the print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu. (P20)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
•Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
memory or the card is formatted.
•Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card’s Write-Protect switch is set to [LOCK].
P [PROTECT]
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
• The settings are canceled when [MENU/
SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to
select the picture.
Press 3/4/2/1
to select the
pictures.
DMC-FX48P_PC~VQT1X57_eng.book 94 ページ ２００８年１２月２６日 金曜日 午後６時２５分