Filter
Top Products
Preparation
27
Setting the Date/Time (Clock Set)
If the message [PLEASE SET THE CLOCK]
appears, set the date and time.
You can go to the setup menu by pressing the
[MENU] button while the message is
displayed.
You can set the year from 2002 to 2099. The
24-hour system is used.
1
Press the [MENU] button.
2
Press 1 to make the setup menu
appear.
• In simple mode, skip this step.
3
Press 3/4 to select [CLOCK SET],
and then press 1.
4
Press 3/4/2/1 to set date and time,
and then press 1.
5
Press 3/4 to select [M/D/Y], [D/M/Y]
or [Y/M/D].
6
Press the [
MENU
]
button twice.
• The menu will disappear.
7
Check if the date/time setting is
displayed correctly, after turning the
camera [OFF] and [ON].
• After a fully charged battery is installed in
the camera for at least 1 hour, the time and
date will be held for approximately 24 hours
if the battery is removed. If the battery was
not fully charged the time may not be
retained properly. If the time/date setting is
lost please reset it.
7
1,6
2,3,4,5
SETUP
2/2
REC
RESET
NO.RESET
ENG
LANGUAGE
CLOCK SET
CLOCK SET
M/D/Y
SELECT SET EXIT
MENU
SELECT SET EXIT
MENU
4,5
3
JAN
10:00
1
2003
.
.