Panasonic DMC-LS2 Digital Camera User Manual


 
Preparation
16
VQT0V10
Do not remove the card or the batteries
while the camera accesses the built-in
memory or a card. The data may be
damaged. (P16)
Remove the batteries after the LCD
monitor and the status indicator
(green) turn off. Otherwise, the settings
on the camera may not be stored
properly.
Inserting/Removing
the Card (Optional)
Check that the camera is turned off and
that the lens is retracted.
You can record or play back pictures
on the built-in memory when you are
not using a card. (P16)
1 Slide the card door to open it.
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
Check the direction of the card.
Do not touch the connection terminals
on the back side of the card.
The card may be damaged if it is not
fully inserted.
3 1 Close the card door.
2 Slide the card door to the end
and then close it firmly.
If the card door cannot be completely
closed, remove the card and insert it
again.
The card and the data may be damaged
if it is inserted or removed while the
camera is on.
We recommend using Panasonic’s SD
Memory Card.
About the Built-in
Memory/the Card
Built-in Memory [ ]
You can record or play back pictures on
the built-in memory when you are not
using a card.
The built-in memory capacity is about
14 MB.
Card [ ]
You can record or play back pictures on
a card.
(The built-in memory cannot be used
when a card is inserted.)
Access to the built-in memory or the
card
The access indication lights red when
pictures are being recorded on the built-in
memory (or the card).
VQT0V10ENG.book 16 ページ 2005年12月27日 火曜日 午後8時34分