Panasonic DMC-LS2 Digital Camera User Manual


 
Others
87
VQT0V10
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P21)
Batteries and the power source
1: The camera turns off immediately
even when battery power is full.
The remaining battery power is low
even if new batteries are inserted.
The remaining battery power may not
be displayed accurately, and the
camera may suddenly stop working,
when the type of battery and the
settings on [BATTERY TYPE] are not
identical. However this is not a
malfunction. Depending on the battery
brand and the operating temperature, or
if exhausted batteries are used, the
remaining battery power may not be
displayed accurately.
– Please check [BATTERY TYPE] (P20)
in the [SETUP] menu.
2: The camera cannot be operated even
when it is turned on.
Are the batteries inserted correctly?
Use sufficiently charged batteries when
using Ni-MH batteries.
3: The LCD monitor turns off while the
camera is turned on.
Is power save mode (P20) or economy
mode (P21) activated?
Press the shutter button halfway to
cancel these modes.
Are the batteries exhausted?
Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
4: The camera turns off immediately
after it is turned on.
Are the batteries exhausted?
Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
If you leave the camera on, the
batteries will be exhausted. Turn the
camera off frequently by using power
save mode (P20), economy mode
(P21), etc.
Recording
1: The picture cannot be recorded.
Is the mode dial correctly set?
Is there any memory remaining on the
built-in memory or the card?
Before recording, delete some
pictures. (P33)
2: The recorded picture is whitish.
The lens is dirty.
The picture can become whitish if there
is dirt e.g. fingerprints on the lens. If the
lens is dirty, turn on the camera, eject
the lens barrel (P10) and gently wipe
the lens surface with a soft dry cloth.
3: The recorded picture is too bright or
dark.
Check that the exposure is correctly
compensated. (P42)
4: The subject is not focused properly.
The focus range varies depending on
the recording mode.
Rotate the mode dial to set the proper
mode for the distance to the subject.
Is the subject beyond the focus range of
the camera? (P24)
Have you taken a picture with jitter?
VQT0V10ENG.book 87 ページ 2005年12月27日 火曜日 午後8時34分