Panasonic DMC-LZ7 Digital Camera User Manual


 
Others
98
VQT1C39
[CANNOT BE SET ON THIS PICTURE]/
[CANNOT BE SET ON SOME PICTURES]
The DPOF print cannot be set to the
pictures not based on the DCF standard.
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY IN
THE CARD]
There is no space left on the built-in
memory or the card.
When you copy pictures from the built-in
memory to the card (batch copy), the
pictures are copied until the capacity of
the card becomes full.
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
When a picture with the same name as
the picture to be copied exists in the copy
destination.
Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
format the built-in memory on the PC etc.
Format the built-in memory on the camera
again. (P84) The data on the built-in
memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognized by
the camera. Format the card again with the
camera after saving necessary data on a
PC etc. (P84)
[PLEASE TURN CAMERA OFF AND
THEN ON AGAIN]
This message appears when the lens is
pressed with the hand etc. and the camera
is not operating properly. Turn the camera
off and on. If the message persists, contact
the dealer or your nearest service center.
[MEMORY CARD PARAMETER ERROR]
Use a card compatible with this unit.
(P5, 16)
You can only use an SDHC Memory Card
if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
An error has occurred accessing the card.
Insert the card again.
[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is
inserted properly and then play back again.
[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card.
Insert the card again and turn the camera
on. Make sure the camera is turned off
before removing or inserting the card to
avoid damage.
[MOTION RECORDING WAS
CANCELLED DUE TO THE LIMITATION
OF THE WRITING SPEED OF THE
CARD]
When you set the picture quality to
[30fpsVGA] or [30fps16:9], we
recommend using a High Speed SD
Memory Card with “10MB/s” or greater
displayed on the package.
Depending on the type of SD Memory
Card or SDHC Memory Card, motion
picture recording may stop in the middle.
VQT1C39ENG.book 98 ページ 2006年12月21日 木曜日 午前10時57分