Filter
Top Products
6
7. Camera/Color Bar Selector (CAM/BAR)
This selector is used to select either the video signal or
the SMPTE color bar signal which is output from the
video output connector (VIDEO), YC (S-VIDEO) output
connector or RGB (D-SUB, 9-pin) output connector.
CAM :The video signal from the camera is output.
BAR : The SMPTE color bar signal is output.
Set this switch to BAR when making video monitor
adjustments and recording the color bar signal.
8. White Balance Selector (ATW/AWC/MANU)
This selector is used to select one of the following
white balance modes.
ATW: In this mode, the color temperature is monitored
continuously and thereby white balance is set
automatically.
AWC: In this mode, accurate white balance is
obtained.
The white balance settings are as follows:
1. Aim the camera at white chart.
2. Press the ITEM (AWC) button on the front
panel to set the white balance.
3. When the auto white balance is completed,
the auto warning indicator first blinks and then
goes off.
If the auto warning indicator remains lit, repeat the
above procedure for setting the auto white bal-
ance.
MANU: The white balance can be adjusted manually
with the red gain (R GAIN) and blue gain controls
(B GAIN).
9. Auto Warning Indicator
This indicator blinks while the white balance or black
balance is being automatically set. This indicator lights
continuously when the white balance or black balance
is set improperly. In this case, follow the auto white
balance or black balance setting procedure.
10. Red and Blue Gain Controls (R GAIN/B GAIN)
These controls are used to manually adjust the white
balance.
These controls only work when the white balance
selection switch (ATW/AWC/MANU) is set to MANU.
Turn the controls clockwise to increase the red and
blue signal levels, and counterclockwise to decrease.
11. Page Button (PAGE)
This button is used to display the SETUP MENU by
pressing it for 2 seconds or more, and to change the
parameters in the SETUP MENU.
12. Item Button (ITEM/AWC)
While the SETUP menu is displayed, this button is
used to move the cursor to the downward.
Normally, when the white balance selection switch
(ATW/AWC/MANU) is set to AWC, this button is used
to set the automatic white balance control (AWC).
13. Left Button (A/ABC)
While the SETUP menu is displayed, this button is
used to move the cursor to the left.
Normally, this button is used to set the automatic black
balance control (ABC).
14. Right Button (B)
This button is used to move the cursor to the right in
the SETUP menu.
15. Scene File Selector (SCENE)
This selector is used to select the scene files.
16. Electronic Light Control ON/OFF Selector
(ELC ON/OFF)
This selector is used to select the electronic light con-
trol from followings.
ON : Enables Electronic Light Control (ELC) mode and
disables Electronic Shutter Speed (SHUTTER)
mode.
OFF : Enables Electronic Shutter Speed (SHUTTER)
mode and disables Electronic Light Control (ELC)
mode.
Note :
• Confirm the setting of the ELC and SHUTTER
parameters on the SETUP menu.
17. Electronic Shutter Speed Control (LEVEL)
This control is used to set the target value of
Electronic Shutter Speed between 1/60 and 1/10
000 second together with the ELC ON/OFF switch.
18. Title Input Connector (TITLE)
This connector is used to connect the optional
Character Generators WJ-KB30 or WJ-KB50.
Note :
The Black & White characters of the generator are
mixed with the video signal and are obtained at
VIDEO OUT, S-VIDEO (Y/C) OUT and RGB/SYNC
OUT connectors.
Colourization of characters is not available.