Filter
Top Products
Camera Monitoring
14
Camera monitoring
using a handset
With a colour display handset (KX-
TGA591AL), you can monitor the image
and sound of the room where the cordless
camera is located. The monitored camera
does not ring, allowing you to easily
monitor a baby’s room, for example, from
different areas of the house.
Important:
LBefore you start monitoring, confirm that
the camera lens of the cordless camera
has been adjusted to the correct angle.
LOnly 1 person can access the cordless
camera at a time.
LA refreshed image taken by the cordless
camera is displayed every few seconds.
The displayed image is not a moving
picture. Selecting enhanced motion
mode shortens the interval (page 11).
LWhile monitoring a cordless camera,
other users cannot make an intercom
call or transfer a call.
LThe monitoring connection is
automatically cancelled after 10
minutes.
LWhile monitoring you cannot place the
handset on the base unit or charger. The
monitoring connection will be cancelled.
LThe cordless camera may not page
handsets in the following conditions:
– when other users are on an intercom
or conference call.
– when electrical interference is emitted
from electrical devices.
– while you are on a call with the
handset. (In this case you will hear 2
tones and z will flash on the
handset.)
Monitoring the cordless camera
from a handset
1 {INTERCOM}
2 Select the desired cordless camera.
i {CALL}
3 Speak to the cordless camera user if
necessary.
OR
To mute your sound output, press
{MUTE} if necessary.
4 When you finish monitoring, press
{OFF} or place the handset on the base
unit or charger.
Adjusting receiver/speaker volume
Push {^} or {V} while monitoring.
Talking to the paged party using the
cordless camera
When the cordless camera is paged from a
handset, the cordless camera does not
ring and the speakerphone is turned on.
Handset
TGA593AL(e).book Page 14 Thursday, April 20, 2006 3:01 PM