Filter
Top Products
10
Power Supply
ªUsing the AC Adaptor
1
Connect the DC Input Lead to the [DC/C.C. IN]
Socket on the Movie Camera.
2 Connect the DC Input Lead to the AC Adaptor.
3 Connect the AC Mains Lead to the AC Adaptor
and the AC mains socket.
≥The AC Mains Lead’s outlet plug cannot be pushed fully
into the AC Adaptor socket. A gap will remain as shown
1.
≥Before connecting or disconnecting the power supply, set
the [VCR/OFF/CAMERA/M-CARD] Switch on the Movie
Camera to [OFF] and make sure that the [POWER] Lamp is
not lit.
ªUsing the Battery
Before use, fully charge the Battery.
1 Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input
Lead is connected to the AC Adaptor, disconnect them.
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and
charging starts.
≥When the [CHARGE] Lamp goes off, charging is
completed.
2 Attach the charged Battery to the Movie Camera.
To Remove the Battery
Set the [VCR/OFF/CAMERA/M-CARD] Switch 2 to [OFF], and
while pressing the [BATTERY RELEASE] Lever
3, slide the
Battery to remove it.
≥When attaching or removing Battery, set the [VCR/OFF/
CAMERA/M-CARD] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.
ªUsing the Car Battery Charger
If you use the Car Battery Charger (VW-KBD2E; optional), you
can supply power to the Movie Camera and charge the battery
inside your car. For further information, refer to the instruction
manual of the Car Battery Charger.
≥Be sure to start the car engine before you connect the Car
Adaptor Cord, otherwise the fuse may blow.
≥For other notes concerning this item, see page 46.
3
2
1
1
1
2
2
3
M-CARD
CAMERA
OFF
VCR
BATTERY
RELEASE
EG-ENG.book 10 ページ ２００３年１月６日 月曜日 午後３時４３分