Filter
Top Products
9
ªInserting a Button-type Battery
Before using the Remote Controller, insert the supplied button-
type battery.
1 While pressing the Stopper 1, pull out the
Battery Holder.
2 Insert the button-type battery with the imprint (i)
facing upward.
3 Insert the Battery Holder into the Remote
Controller.
≥When the button-type battery is weak, replace it with a new
CR2025 battery. (A battery is normally expected to last about
1 year. However, it depends on operation frequency.)
≥Make sure to match the poles correctly when inserting the
battery.
.....................................................................................................
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the equipment manufacturer. Discard
used batteries according to manufacturer’s instructions.
.....................................................................................................
WARNING
Risk of fire, explosion and burns. Do not recharge,
disassemble, heat above 100xC or incinerate. Keep the
Button-Type battery out of the reach of children. Never put
Button-Type battery in mouth. If swallowed call your doctor.
.....................................................................................................
ªUsing the Remote Controller
1
Direct the Remote Controller to the Remote
Control Sensor of the Movie Camera and press an
appropriate button.
≥Distance from the Movie Camera: Within approximately
5metres.
≥Angle: Within approximately 15o in the vertical and
horizontal directions from the central axis.
≥The above operating ranges are for indoor use. Outdoors or
under strong light, the Movie Camera may not operate properly
even within the above ranges.
≥For other notes concerning this item, see page 46.
1
3
2
1
1
15˚
15˚
15˚
15˚
EG-ENG.book 9 ページ ２００３年１月６日 月曜日 午後３時４３分