Filter
Top Products
Preparation
17
VQT0V63
∫ Strap (supplied)
1 Pass the strap through the hole at
the strap eyelet.
2 Pass the strap through the
stopper and fasten the strap.
A: Pull the strap 2 cm or more.
• Attach the strap to the other side of the
camera being careful not to twist it.
• Check that the strap is firmly attached to
the camera.
• Attach the strap so that you can see the
“L
UMIX” logo.
Attaching the Lens
Hood
In bright sunlight or backlight, the lens hood
will minimize lens flare and ghosting. The
lens hood cuts off excess lighting and
improves the picture quality.
• Check that the camera is turned off and
that the lens is retracted.
• Close the flash.
1 Attach the hood adaptor
(supplied).
• Do not tighten the hood adaptor too
much.
2 Place the camera upside down,
align the mark on the lens hood
with the mark A on the camera
and then insert the lens hood.
3 Tighten the screw.
• Check if the screw is loose and then
attach the lens hood.
• Do not tighten the screw too much.