Filter
Top Products
Before using
17
LSQT0861
ª Removing the battery
While sliding the [BATT] lever, slide the battery
(or the DC input lead) to remove it.
≥Hold the battery with your hand so it does not
fall.
Charging time and recordable time
The times shown in the table below show the
times at a temperature of 68oF (25oC) and a
humidity of 60%. This is just a guide. If the
temperature is higher or lower than the specified
value, the charging time will become longer.
A Charging time
B Maximum continuously recordable time
“1h. 10 min.” indicates 1 hour 10 minutes.
≥The battery CGA-DU12 is supplied.
≥The times shown in the table are rough
estimates. The times indicate the recordable
time when the viewfinder is used. The times in
parentheses indicate the recordable time when
the LCD monitor is used.
≥We recommend the Battery Pack CGA-DU12
and CGA-DU21 for long recording time (2 hour
or more for continuous recording, 1 hour or
more for intermittent recording).
≥The recordable time will become shorter in the
following cases:
≥When you use both the viewfinder and the
LCD monitor simultaneously while rotating
the LCD monitor frontward to record yourself,
0 Lux MagicPix function, etc.
≥When you use this Camcorder with the LCD
monitor lit up by pressing the [POWER LCD]
button.
≥When you use accessories fitted on the
Camcorder’s smart accessory shoe such as
the stereo zoom microphone and video DC
light, etc..
≥The batteries heat up after use or charging. The
Camcorder being used will also heat up. This is
normal.
≥Along with the reduction of the battery capacity,
the display will change: r # s #
t # u # v. If the battery
discharges, then u (v) will flash.
Inserting/removing a cassette
1 Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥When the cover is fully opened, the cassette
holder will come out.
2 After the cassette holder is opened, insert/
remove the cassette.
≥When inserting a cassette, orient it as shown
in the figure, and then securely insert it as far
as it goes.
≥When removing, pull it straight out.
3 Push the [PUSH] mark 1 in order to close
the cassette holder.
4 Only after the cassette holder is completely
housed, close the cassette cover.
≥After using, make sure to rewind the cassette
completely, remove it, and put it in a case. Store
the case in an upright position. (
-74-)
≥When condensation is formed on the lens or the
main unit of the Camcorder, even if no
condensation alarm is indicated, condensation
may have formed on the heads or the cassette
tape. Do not open the cassette cover. (
-72-)
Supplied
battery/
CGA-DU12
(7.2 V/
1150 mAh)
A 2 h. 25 min.
B 2 h. 15 min.
(2 h. 5 min.)
CGA-DU21
(7.2 V/
2040 mAh)
A 3 h. 55 min.
B 4 h.
(3 h. 45 min.)
CGR-DU06
(7.2 V/
640 mAh)
A 1 h. 40 min.
B 1 h. 15 min.
(1 h. 10 min.)
BATT
OPEN
/
EJEC
T
PUSH
1
LSQT0861Eng.book 17 ページ ２００４年１２月２２日 水曜日 午後２時３４分