Filter
Top Products
Record mode
31
LSQT0973
ª To use the zoom microphone function
Interlocked with the zooming operation, the
microphone will clearly capture sounds far away
with the tele-shot or those in the vicinity with the
wide-angle shot.
≥Set to Tape Recording Mode.
1 Set [ADVANCE] >> [ZOOM MIC] >> [ON].
ª
About the variable speed zoom
function
≥When pushing the [W/T] lever as far as it will go,
you can zoom from 1k to 10k in 2.1 seconds at
the maximum.
≥The zoom speed varies according to the amount
of movement of the [W/T] lever.
≥The variable speed zoom function cannot be
used with the remote control.
Recording yourself
You can record yourself while viewing the LCD
monitor. You can record persons in front of the
Camcorder while showing them the image. The
image is horizontally flipped as if you see a mirror
image. (The image to be recorded is the same as
that recording.)
1 Rotate the LCD monitor towards the lens
side.
≥When the LCD monitor is opened, the
viewfinder will be automatically turned off. If the
LCD monitor is rotated towards the lens side
though, then the viewfinder will be activated.
≥When the LCD monitor is rotated towards the
lens side, the icon will not be displayed even if
you push the center of the joystick.
Quick start
This Camcorder will be put into standby in
approx. 1.7 seconds after the power is turned on.
≥Please note in Quick Start Mode approximately
half the pause recording power is being
consumed. Using Quick Start Mode will reduce
the battery recording/playback time.
≥This is only activated in the following cases.
≥A tape or a card is inserted, while the Tape
Recording Mode is set.
≥A card is inserted, while the Card Recording
Mode is set.
1 Press the [QUICK START] button.
≥The quick start recording lamp lights up.
(Press the button again to cancel it.)
2 Set the [OFF/ON] switch to [OFF].
≥The quick start is now ready.
3 Set the [OFF/ON] switch to [ON].
≥This Camcorder will be put into a recording
pause in approx. 1.7 seconds after it is turned
on.
ª
To cancel the quick start when the
[OFF/ON] switch is set to [OFF]
Press and hold the [QUICK START] button for
approx. 2 seconds. The lamp will go off and the
Camcorder will be completely turned off.
≥If the standby continues for approx. 30 minutes,
then the lamp will go off and the Camcorder will
be completely turned off.
≥When you rotate the mode dial or remove the
battery, the quick start recording lamp is turned
off and the quick start mode is canceled. If the
Camcorder is turned on and the Tape/Card
Recording Mode is set though, the lamp turns
on and the quick start mode is restored.
ZOOM
ZOOM
ZOOM
START
QUICK
OFF ON
LSQT0973ENG.book 31 ページ ２００６年１月３０日 月曜日 午前１１時４０分