Filter
Top Products
With a PC
54
LSQT0973
DV DATA Streaming Function
When the OS is Windows XP the Camcorder can
be connected to the personal computer with the
USB cable, however, Video Stream Driver must
be installed.
≥Do not connect the USB cable until the Video
Stream Driver is installed.
ª
Operating environment
OS:
IBM PC/AT compatible personal computer with
pre-installed
Microsoft Windows XP Home Edition/
Professional SP1/SP2
Interface:
USB 2.0 (Hi-Speed compliant) — A type
DirectX 9.0b/9.0c
Windows Media Player 6.4 to 10
Other requirements:
Mouse
ª
Installing Video Stream Driver
Install this when your OS is Windows XP SP1/
SP2. (When your OS is Window XP SP2 installing
video stream driver is not needed.) Video Stream
Driver must be installed when you connect the
Camcorder to the PC with the USB cable.
DirectX 9.0b is installed in your PC if it is not
installed beforehand.
≥When DirectX 9.0b is installed, applications
supported by previous versions of DirectX may
not run. In this case, consult the manufacturers
of the applications disabled.
1 Insert the supplied CD-ROM into the
personal computer’s CD-ROM drive.
≥Quit all applications.
≥[Setup Menu] appears.
2 Click [Video Stream Driver].
≥The set up program starts running.
3 Depending on your system environment,
installation of “DirectX 9.0b” may be
required. Click [Yes] and continue with
installation.
≥After “DirectX 9.0b” is installed, the computer
will restart.
≥Do not remove the CD-ROM.
≥Installation may take a little while.
4 Finish installation by following the
on-screen instructions.
≥Click [Next] and proceed with installation.
≥After completing the installation, Click
[Finish].
5 Click [OK].
ª
Connecting Computer and Camcorder
If you wish to capture data from a tape, set the
Camcorder to Tape Playback Mode and insert the
tape. If you wish to capture images from the lens
of the Camcorder, set the Camcorder to the Tape
Recording Mode and remove the tape and the
card.
With USB connection cable (supplied)
OS:
Windows XP SP1/SP2
≥The personal computer should be compatible
with USB 2.0 Hi-Speed.
Confirmation before connection
When you connect the personal computer and the
Camcorder with the USB connection cable and
then use DV DATA on Windows XP (SP1/SP2),
check the driver of the USB host controller.
≥It is required to use the driver for which
[Microsoft] is displayed on [Driver Provider] in
[Driver] tab.
1 Select [start] >> [Settings] >>
[Control Panel] to start [System].
≥[System Properties] is displayed.
2 Click [Hardware] tab and then click
[Device Manager] then
[Universal Serial Bus Controller].
3 Right-click [Enhanced Host Controller] and
then select [Properties].
≥The indication [Enhanced Host Controller] is
changed as [EHCI] depending on the host
controller you use.
4 Click [Driver] tab to check the description
on [Driver Provider].
≥If [Microsoft] is displayed on [Driver Provider],
the confirmation procedure is completed.
LSQT0973ENG.book 54 ページ ２００６年１月３０日 月曜日 午前１１時４０分