Filter
Top Products
You can also use the LCD monitor to _-Before you begin
playback your recording. | Connect the Palmcorder to a power
| source. (See pages 11, 12.)
| insert a recorded cassette.
VOLUME KEY L* Set POWER to VCR.
1LCD-OPEN 1 Press LCD-OPEN to unlock the LCD
Button _ monitor and swing open.
2
\ Press REWIND/SEARCH to rewind
the tape.
2REWIND/
4STOP SEARCH 3PLAY Button
Button Button
180°
-Bui_t-in
Speaker
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.
Press PLAY to start playback.
To adjust the volume:
A Hold down VOLUME KEY until the
volume setting screen appears.
(See page 20).
B Rotate VOLUME KEY to adjust the
volume of the built-in speaker. To
remove the volume setting screen, hold
down VOLUME KEY again.
•Adjust the picture on the LCD monitor if
needed. (See page 23.)
Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than 5
seconds, the Patmcorder will go into
Repeat Playback mode when the
tape reaches its end. The letter "R 1>"
will appear in the EVF and LCD
monitor.
To exit the Repeat Playback mode,
turn the Palmcorder OFF.
Jack
• When a lape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
* You can connect earphones (not
supplied) to the PHONE Jack.
27