Filter
Top Products
Source(Playing)
Palmcorder
(Supplied)
Cable (not
supplied)
To Audio In
JT
,-Before you begin
• Connect both Palmcorder and VCR to
their power sources.
• Connect the Palmcorder to a VCR as
illustrated left.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE,
• Set the Palmcorder POWER Switch to
VCR.
1
TV 2
(To View)
Connecting
CabLe
(not supplied)
Audio In Video In 4,
R_cording5
:R (Rear)
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PAUSE.
Place the VCR into RECIPAUSE
mode. (See VCR manual)
Simultaneously, press PAUSE on
both units to begin copying.
Press STOP on both units when
copying is completed. •
I_FIF4
S-Video In
To Video In To S-Video In
(If there is S-Video In)
!Lvt[.],1i(.'rA,,_ it ,IML.],!I | |}1 I
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
• For technical reasons, dubbing a tape may
reduce its quality.
• Press DISPLAY ON TV on the Palmcorder
remote control (optional, page 49) to
eliminate EVF!LCD Monitor indications.
• If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
• Only the DATEFrtME, when displayed, wil
be recorded on the tape.
_bU_ CAUTION: ...............
!
authorized exchanging and/or |
pying of copyrighted recordings may
J
copyright infringement.
43