Filter
Top Products
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone.
- Built-in
Microphone
Switch
3ADUB Button 2PAUSE Button
\
Before you begin I
Turn on the Palmcorder.
• Insert a pre-recorded tape to be
dubbed.
The AUDIO-RIEC setting in CAMERA
MENU mode should be as fo]lows:
12 bit
16 bit
The original sound is recorded
on ST (Stereo) 1, and the new
sound will be recorded on ST
(Stereo.) 2.
The original sound is replaced
with the new sound.
• Select 12 bit if you do not want the
original sound to be completely replaced
during an audio dub.
• If you dub over a tape which has both
12 bit and 16 bit audio recordings on it,
keep in mind that the original 16 bit audio
portion will be completely replaced.
1
2
Set POWER to VCR.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
VCR position.
• If you have the Optional Remote
Control, you can set the Palmcorder
to stop automatically at a specified
point on the tape. See "Memory-Stop
Editing" on page 42.
Press PLAY.
Then press PAUSE where you want
dubbing to begin.
2PLAY Button
3
Press A.DUB on this unit (for three
seconds) or on the remote control
(optional, see page 49) to put the
Palmcorder in the Audio Dub mode.
• "ADUB" flashes in the EVF or the
LCD monitor.
EVFILCD Indication
41