Filter
Top Products
69
LSQT1211
Editing
≥ The DPOF setting can be established for up to
999 files.
≥ DPOF setting made on other devices may not
be recognised by this unit. Please perform the
DPOF settings on this unit.
≥ You cannot add the recording date to pictures
to be printed with the DPOF settings.
[HDD] [SD]
¬Rotate the mode dial to select .
1 Press the MENU button, then
select [PHOTO SETUP] #
[COPY] # desired direction and
press the joystick.
2 Select [SELECT] or [ALL] and
press the joystick.
≥ When [ALL] is selected, all still picture files in
the HDD or SD card will be copied. Proceed to
step 5.
3 (Only when [SELECT] is selected in step 2)
Select the file to be copied, then
press the joystick.
The selected file is encircled by a red frame.
≥ When the joystick is pressed again, the
selected file will be cancelled.
≥ Up to 50 files can be set in succession.
≥ The files are copied in the order that they were
selected.
4 (Only when [SELECT] is selected in step 2)
Press the MENU button.
5 When the confirmation message
appears, select [YES], then press
the joystick.
Copying of the file starts.
(Only when [SELECT] is selected in step 2)
To continue copying other files
Repeat steps 3-5.
To cancel copying halfway
Press the MENU button.
To complete editing
Press the MENU button.
≥ The copied files are recorded after the still
picture files in the copy destination. (The file
names or the folder names will differ from the
original file.)
≥ The lock and DPOF settings of the file cannot
be copied.
≥ In case of [ALL], the copy may take time if
there are many files.
≥ Do not turn off this unit while copying.
≥ When you copy files, use a battery with
sufficient battery power or use the AC adaptor.
≥ Do not open the card slot cover while copying.
The copying will stop.
Copying still picture files
This is for copying still picture files
from the HDD to an SD card or vice
versa.
Copying from the HDD to an SD card
Copying from an SD card to the HDD
MENU
LSQT1211(PAL_ENG).book 69 ページ ２００７年２月１３日 火曜日 午後１時１４分