Panasonic WV-CP500 Security Camera User Manual


  Open as PDF
of 35
 
27
Back focus setting [BACK-FOCUS SETUP]
Selects the back focus setting type and performs fine adjustment. The following setting can be configured on the "BACK-
FOCUS SETUP" screen displayed from the top screen. Refer to page 5 for how to call up the screen.
The lens adjustment (☞ Installation Guide) shall be performed before the back focus adjustment.
<Back focus adjustment>
The back focus adjustment is performed by changing the distance between the lens and focal point.
Follow the procedure below.
Important:
• Theautobackfocusfunctionisusedforbackfocusadjustmentatinstallationandforfocuscorrectionatswitchingbetween
the color and black-and-white modes after installation. This function is not a function that is supposed to be operated contin-
uously such as the auto focus function.
• Whenfocusmissingoccursduetosecularchangeinthelensandinstallationenvironmentorperipheraltemperature
change, the back focus adjustment is required again.
Note:
• Thebackfocusadjustmentcanbealsoperformedthroughtheoperationbuttons.(+ Installation Guide.)
Step 1
Move the cursor to "PUSH SW" of "ABF" and press the setting button.
→ The auto back focus function provides back focus adjustment to automatically focus on a subject located in the center of the
screen.
Step 2
To fine adjust the back focus, move the cursor to "MANUAL-ADJ", press the setting button, and use the right or left button to
adjust the back focus manually.
Note:
• Pressingtherightandleftbuttonssimultaneouslyformorethan2secondsresetsthebackfocuspositiontotheCSmount
default position.
• Thevalueof"INDICATOR"isaguidetoadjustthebackfocus.Thelargerthevalueis,thesharpertheimagebecomes.
"BACK-FOCUS SETUP" screen
**BACK-FOCUS SETUP**
ABF PUSH SW
MANUAL-ADJ
C/L B/W AUTO
SETUP-SW LOCK OFF
NEAR FAR
.........
|
.........
INDICATOR XXXX FOCUSING
RET TOP END
 previous next