Filter
Top Products
-16-
(9) Auto Focus (AF MODE)
The camera adjusts the focus automatically by sens-
ing the center of the picture. S, M and L stand for
the size of the sensing area: Small, Middle and
Large.
See page 40 for details.
MANUAL S, M, L: Auto-focus is activated only when
the AF key on the controller is pressed.
AUTO S, M, L: Auto-focus is activated automatically
while a manual pan, tilt or zoom operation is per-
formed.
Note: If SENS UP is set to ON except x2 FIX or x2
AUTO, the AUTO (S/M/L) mode is disabled and
the MANUAL (S/M/L) mode is automatically
selected.
(10)
Special 2 Menu (SPECIAL2)
This menu allows you to adjust and set up the fol-
lowing items and functions: chroma level, aperture
level and pedestal level.
You can also reset your parameters to the factory
default settings.
See page 40 for the setting.
(11)
Self-diagnosis Function
If the camera continues operating abnormally for 30
seconds or more due to such accident as external
noise, the camera will automatically reset its power.
In the case it happens frequently, check if there
would be any environmental cause.
● RS485 Communication
Refer to the following pages for the communication
parameter settings.
• Full/Half duplex (page 45)
• Transmission speed (4 900 - 19 200 bps) (page 45)
• Parity bit, Stop bit, Flow control (page 43)
• Wait time, Delay time, Alarm output (page 43)
• Camera units (96 units max.) (page 43)
• Termination ON/OFF (page 43)
• Reset parameters (page 43)