Filter
Top Products
11.14 Configure the VIQS area
The VIQS area is specified by following the steps below.
1. Drag the mouse on the screen to specify the area.
→ The specified area is displayed with a white frame.
Note
• A selectable area is limited.
2. Select [On]/[Off] to activate/deactivate a distributed image of [VIQS(H.264(1))] or [VIQS(H.264(2))].
3. Click the [Set] button.
→ This unit is updated with the setting contents. To delete the specified area, click the [Delete] button.
IMPORTANT
• No setting contents are determined unless the [Set] button is clicked.
• To check the window after VIQS setting, display an H.264 image on the “Live” page.
Operating Instructions 129
11 Configure the settings relating to images and audio [Image/Audio]