Panasonic WV-NP502 Series Security Camera User Manual


 
Note
When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
Audio may temporarily be interrupted and noise may be heard when multiple users are accessing the
camera concurrently. It may be possible to diminish the interruption or noise by setting a longer interval
for “Audio output interval (PC to Camera)”.
Audio may sometimes not be heard depending on the network environment.
[Audio output port (PC to Camera)]
Enter the transmission port number (the port number on the camera used to receive audio data transmitted
from the PC).
Available port number: 1024-50000 (Only even numbers are available.)
Default: 34004
Note
The transmission port number entered for “Audio output port (PC to Camera)” will be used only when
“Unicast port (MANUAL)” is selected for “Transmission type” (®page 79, page 86).
When “Off” is selected for “H.264 transmission” (or “MPEG-4 transmission”) (®page 79, page 86) or
when “Unicast port (AUTO)” or “Multicast” is selected for “Transmission type”, it is not necessary to
enter the transmission port number.
[Permission level of audio trans./recep.]
Select an access level for audio transmission/reception from the following.
1. Level 1 only/ 2. Level 2 or higher/ 3. All users
Default: 3. All users
Note
Refer to page 153 for further information about the access level.
132 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]