Panasonic WV-SP105E Security Camera User Manual


  Open as PDF
of 64
 
38
38
39
Configure the settings relating to the host authentication
[Host auth.]
Click the [Host auth.] tab on the "User mng." page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
The restriction settings of PCs (IP address) from accessing the camera can be configured on this page.
[Host auth.]
Select"On"or"Off"todeterminewhetherornotto
authenticate the host.
Default:Off
[IP address]
Enter the IP address of the PC to be allowed to access
the camera. Host name cannot be entered for the IP
address.
Note:
•When"IPaddress/subnetmask"isentered,itis
possible to restrict PCs in each subnet. For exam-
ple, when "192.168.0.1/24" is entered and "2.
Camera control" is selected for the access level, the
PCs whose IP address is between "192.168.0.0" -
"192.168.0.255" can access the unit with the
access level "2. Camera control".
•WhentheIPaddressalreadyinuseisenteredand
the [Set] button is clicked, the respective host infor-
mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1. Administrator/ 2. Camera control/ 3. Live only
Refer to page 38 for further information about the
access level.
Default: 3. Live only
[Host check]
By clicking [C] of "Host check", the registered host can
be selected and the selected host’s IP address can be
checked.
The registered IP address will be displayed with the
access level.
(Example:192.168.0.21[1])
To delete the registered host, click the [Delete] button
after selecting the IP address to be deleted.
 previous next