Filter
Top Products
8 C2462M-D (3/08)
Install the Back Box
The installation methods for the ICS090 Series include the following options:
• Mount to the surface of a ceiling or wall
• Install in a suspended ceiling
• Install in a fixed ceiling or wall
• Mount to the surface of a 4S standard electrical box
• Install in a 4S deep electrical box
Select the best method for your installation and refer to the following pages for instructions.
INSTALLATION TO SURFACE OF A CEILING/WALL
Refer to Figure 2 for the following steps. Refer to Figure 3 if installing the unit to a concrete ceiling/wall.
1. Pull video and power wires through the ceiling/wall.
2. Connect the video cable/wires.
BNC: Connect the BNC connector from the Camclosure to a mating BNC connector.
Twisted pair: Connect the blue wire to Video +; connect the gray wire to Video -.
3. Connect the power wires.
AC operation only: If you are wiring more than one ICS090 Camclosure to the same transformer,
connect one side of the transformer to the red wire on all units, and then connect the other side of the
transformer to the black wire on all units. Failure to connect all of the units in the same way will cause
the cameras to be out of phase with each other, which might produce a vertical roll when switching
between cameras.
Table A. Power Input: Surface of Ceiling/Wall Installation
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~