Filter
Top Products
18 Pelco Manual C466M-E (6/99)
Figure 4. Receiver/Driver Reset Button Location
4.6 PATTERNS
1. The DRD***2* units are capable of one 60-second pattern. This pattern can
consist of any standard pan/tilt or lens command. Presets, flip and turbo are
not allowed in a pattern. Zone scan can be enabled while running a pattern.
2. To program a pattern first move the pan/tilt and adjust the lens to the starting
point desired. Engage the Pattern Programming command. The message
“PROGRAMMING PATTERN” will be displayed. After this, any movement for
the next 60 seconds will be remembered by the DRD. To create a pattern that
plays back only once, continue programming until the message is removed.
To create a pattern that repeats you must terminate the program before the
time-out occurs and the DRD removes the message.
3. To play back a pattern, engage the Run Pattern command. The unit will move
to the defined starting position and display the message “RUNNING PATTERN”.
Any subsequent command will terminate the pattern.
4.7 CLEAR VIDEO SCREEN
To clear the video display of any text supplied by the DRD, engage the Clear Video
Text command.
4.8 RESET
On all units except the DRD***11 models, there is a reset switch on the CPU board
(refer to Figure 4). If the dome drive stops working, try resetting it by pushing the
reset switch for 10 seconds. In about 15 seconds, if the unit is working, it will begin
to move and go through its start-up routine. You may also be able to issue a reset
command from your controller; check the documentation for your controller.
RESET BUTTON