6 Pelco Manual C480M-F (10/04)
Figure 3. HS8000CA Ceiling Adapter Plate Installation
3.4 HS8000CA CEILING ADAPTER PLATE INSTALLATION
(For HS8000 only)
Before installing the HS8000CA ceiling adapter plate, make sure the mounting sur-
face is able to support the full load of the enclosure, mount, and all other equipment
such as the camera, lens, etc.
To install the HS8000CA ceiling adapter plate, perform the following:
1. Place the HS8000CA ceiling adapter plate on the HS8000 enclosure as shown
in Figure 3.
2. Next, drill six (6) 0.187" (3/16") holes in the enclosure at the location of each of
the mounting holes on the HS8000CA ceiling adapter plate.
3. Place a nylon washer on the 10-32 screw and insert it through the HS8000CA
ceiling adapter plate mounting hole and the hole in the enclosure drilled in
step 2. Then install a nut on the 10-32 screw and tighten. Repeat this step for
each of the six (6) mounting holes.
4. Mount the enclosure as described in Section 4.2 of this manual.
NOTE:
The HS8000CA ceiling
adapter plate is provided with six (6)
10-32 screws, nuts and nylon wash-
ers. Before continuing with the instal-
lation of the adapter plate, make sure
these six screws, nuts and washers
are included. If not, please contact the
factory to obtain them.
NOTE:
The HS8000CA Ceiling
Adapter is not compatible withe the
HS8013 enclosure
