Filter
Top Products
14 C3432M-G (4/09)
404 PLASTER RING INSTALLATION
1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the
cover from the back box.
2. Pull the cable and wires into the cover. Use three 6-32 x
0.75-inch Phillips pan head screws
(supplied) or two 8-32 x 0.75-inch Phillips pan head screws (supplied) to attach the cover to an
installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.
3. Install the camera module into the back box before instal
ling the back box into the cover. Rotate the
camera module to access the mounting holes inside the back box (refer to Camera Module on
page 19 for more information).
4. Connect the cable and wires (refer to Wiring Tables on page 16 for info
rmation).
Figure 7. 404 Plaster Ring Installation
5. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and
washers (removed
earlier) to secure the back box to the cover.
6-32 X 0.75-INCH
OR 8-32 X 0.75-INCH
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED)
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
COVER
BACK BOX
CEILING/
WALL
404 PLASTER RING
(NOT SUPPLIED)