Filter
Top Products
C3432M-G (4/09) 15
SIDE CONDUIT INSTALLATION
1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the
cover from the back box.
2. Remove the conduit plug from the cover. Install a 0.7
5-inch (1.91 cm) threaded conduit connector
(not supplied) into the conduit hole in the cover.
3. Attach the cover to the mounting surface (hardware not supplie
d). Use stainless steel hardware
when installing the system outdoors.
4. Install the camera module into the back box before instal
ling the back box into the cover. Rotate the
camera module to access the mounting holes inside the back box (refer to Camera Module on
page 19 for more information).
5. Connect the cable and wires (refer to Wiring Tables on page 16 for information).
Figure 8. Sid
e Conduit Installation
6. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and
washers (removed
earlier) to secure the back box to the cover.
COVER
BACK BOX
8-32 X 0.375-INCH
PHILLIPS PAN HEAD
SCREWS WITH WASHERS
(SUPPLIED)
0.75-INCH CONDUIT
CONNECTOR
REMOVE
CONDUIT PLUG