Filter
Top Products
C4601M-C (7/11) 13
Figure 8. Attaching Support Rails
7. Repeat the previous step for the second support rail assembly.
8. Tighten the 8-32 x 0.375-inch Phillips truss head screws that were attached to the front- and rear-mount rails (refer to Figure 6 on page 11).
9. Place the unit onto the mount rails by sliding the chassis brackets onto the rails (refer to Figure 9 on page 14). This step may require two
people to lift and slide the unit into place. The unit should slide in and out of the rack easily.
WARNING: When sliding out the Endura workstation, be careful not to let the unit fall out of the rack.
REAR- RAILMOUNT
FRONT- RAILMOUNT
(4) SCREWS,
10-32 X 0.5-INCH
PHILLIPS FLAT HEAD
(4) SCREWS,
10-32 X 0.75-INCH
PHILLIPS PAN HEAD
RACK FRONT RACK REAR