Filter
Top Products
C4601M-C (7/11) 9
Figure 3. Rack Mount Kit
PRODUCT SERIAL NUMBER LABEL PLACEMENT
Product serial number labels help Pelco Product Support identify your system and its factory configuration if your Endura workstation or its
components require service.
Three labels citing your product’s serial number are attached to the Endura workstation. One label is attached to the bottom of the Endura
workstation. A second label is attached to the front panel of the unit, behind the bezel.
Because rack mounting and other installation options may obscure the factory-applied labels, a third label is provided for you to attach to your
product documentation or another product location that will not be obscured by installation.
To use this label:
1. Locate the small label attached to the outside of the front bezel with a yellow sticker that reads “Extra serial number label: remove prior to
installation.”
2. Remove the yellow sticker.
3. Peel away the backing of the small white label and attach it to this Installation manual, other product documentation, or an unobscured
product location.
Figure 4. Extra Product Serial Number Label
REAR MOUNT RAIL
2 EA.
FRONT MOUNT RAIL
2 EA.
SHOWN ACTUAL SIZE
CHASSIS MOUNTING
BRACKETS
PHILLIPS FLAT
HEAD SCREW,
10-32 X 0.5-INCH
4 EA.
PHILLIPS PAN
HEAD SCREW,
10-32 X 0.75-INCH
4 EA.
PHILLIPS TRUSS
HEAD SCREW,
8-32 X 0.375-INCH
6 EA.
PHILLIPS PAN
HEAD SCREW,
10-32 X 0.25-INCH
8 EA.
CAGE NUT,
10-32
10 EA.
RACK MOUNT KIT
03267-39-0020
SN