Pentax 1938507 Digital Camera User Manual


 
265
Appendix
12
In rare cases, the camera may not operate correctly due to static electricity. This
can be remedied by taking the battery out and putting it back in again. When the
mirror remains in the up position, take the battery out and put it back in again.
Then, turn the power on. The mirror will retract. After the procedure is done, if the
camera operates correctly, it does not require any repairs.
* Refer to p.11 of the “PENTAX PHOTO Browser 3/PENTAX PHOTO Laboratory
3 Operating Manual” for details on connecting the camera to a PC.
AE lock
function does
not operate
AE lock is not
available when set
to B (Green), p
(Bulb) or M (Flash
X-sync speed)
mode
Use AE lock with any setting other than B
(Green), p (Bulb) or M (Flash X-sync
speed) mode.
The flash
does not
discharge
The Capture mode
is set to B (Green)
mode
Only
C
(Auto discharge) and
D
(Auto
flash+Redeye reduct) are available for the
Flash Mode when the Capture mode is
B
.
The flash will not discharge when the subject
is bright in these modes. In the Capture modes
other than
B
, only the flash mode that
discharges every time the flash recharges is
available. Try different Capture modes.
The USB
connection with
a computer
does not work
properly*
The Transfer Mode
is set to
[PictBridge]
Set [USB Connection] in the [R Set-up]
menu to [PC].
The USB
connection
with a printer
does not work
properly
The Transfer Mode
is set to [PC]
Set [USB Connection] in the [R Set-up]
menu to [PictBridge]. (p.208)
Shake
Reduction
does not work
The Shake
Reduction function
is off
Turn on the Shake Reduction switch.
The Shake
Reduction function
is not set properly
If a lens for which focal length information
cannot be acquired is used, set the [Focal
Length] on the [Input Focal Length] menu.
(p.67)
Shutter speed is
too low for the
Shake Reduction
function to be
effective when
panning or
shooting night
scenes, etc.
Turn off the Shake Reduction function and
use a tripod.
The subject is too
close
Move away from the subject, or turn off the
Shake Reduction function and use a tripod.
Problem Cause Remedy
e_kb442.book Page 265 Tuesday, December 18, 2007 6:39 PM