Filter
Top Products
16
Getting Started
MultiMediaCards and the SD Memory Card can be used with this
camera. Captured images or recorded voice are recorded on the SD
Memory Card/MultiMediaCard. Make sure that the camera is turned off
before inserting or removing the SD Memory Card/MultiMediaCard.
z Open the battery chamber/card cover.
x Rotate the card with the surface of the card having
the ̆ symbol facing towards the lens and with the
pin-connector edge of the card towards the slot and
insert fully until it clicks.
If the card is not inserted correctly, images and voice memos may
not be recorded properly.
c Close the battery chamber/card cover.
To remove the card, eject the card by pressing it in the direction
indicated by the arrow, and pull it out.
● Approximate Number of Recordable Images and Recorded
pixels/Quality levels
Quality levels
Best Better Good Movie images voice
Recorded pixels
(ȢȢȢ)(ȢȢ)(Ȣ) (320 × 240)
recording
2288 × 1712 Approx. 5 Approx. 10 Approx. 15
1600 × 1200 Approx. 11 Approx. 20 Approx. 27 Approx. Approx.
1024 × 768 Approx. 25 Approx. 45 Approx. 56 40sec. 30min.
640 × 480 Approx. 53 Approx. 82 Approx. 100
• The above table indicates the number of images when using a 16MB SD Memory Card.
• The above table is based on standard shooting conditions specified by PENTAX and may
vary depending on the subject, shooting conditions, capture mode, SD Memory Card, etc.
Installing the SD Memory Card/MultiMediaCard
Battery chamber/
card cover
SD Memory Card/
MultiMediaCard