Philips PCA635VC Digital Camera User Manual


 
Safety Tips
Before you install this product, be sure to safeguard yourself, your computer system and the Philips PCA635VC. It is
recommended that you follow these precautions in addition to any precautions you may have found in other documents
for your computer.
Shut down and disconnect system power prior to plugging and unplugging connectors.
Do not plug an excessive amount of devices into a power outlet and do not run more than one power strip off any
outlet.
On rare occasions, some installations of the Philips PCA635VC may require opening the system itself to install a com-
patible ECP parallel printer port card (obtained from local computer store). If you find this necessary, be careful of the
sharp edges inside the computer and note the safety instructions of the product you are installing.
Maintenance
If you observe the following guidelines, you will prevent defects and the camera will be used safely.
The outside of the camera can be cleaned with a soft cloth.
Do NOT use cleaning fluids based on alcohol, methylated spirit, ammonia, etc..
Avoid direct contact with water.
If the lens has to be cleaned, use a special lens cleaning tissue, available at any good camera store.
You can use the camera only indoors.
Keep the camera free from oil, vapour, steam, moisture and dust.
Keep the camera away from a heater, lighting equipment and direct sunlight.
Never direct the lens of your camera towards the sun.
To prevent fire or shock hazard, do not exposure this camera to rain or moisture. Do not attempt to disassemble the came-
ra. In order to prevent shock and fire hazard, do not remove screws or covers.
There are no userserviceable parts inside.
Important: Use a power that meets the requirements according to EN 60950 only. For USA: Use a UL listed 5V, 2.5 Watt
DC power supply compliant with UL 1950.
8