Filter
Top Products
Appendix B -- Mounting the Detector 23
Spec 10 LN with Integrated Shutter
Tools:
9/64” hex wrench
5/32” hex wrench
Procedure:
1. Locate the Spec 10 LN detector with an internal shutter and its adapter flange.
2. If another adapter is mounted to the LS 785, remove that adapter (and, in the case of the PIXIS, the
adapter and spacer).
3. Using a 9/64” hex wrench, remove the four #8/32 socket head screws with washers from the face of the
LS 785.
4. Using a 5/32” hex wrench, attach the adapter to the Spec 10 mounting flange with three #10-32 socket
head screws.
5. Using a 9/64” hex wrench, attach the Spec 10 LN and adapter to the LS 785 with three #8-32 socket head
screws and washers as shown in the photograph. Store the fourth socket head screw and washer since all
four screws and washers will be needed if you change over to a PIXIS detector.
Note: If an external shutter is installed on the LS 785, it must be held open by a separate controller.
Label
“Top”
3 x #8-32
Socket Head
Screws with
Washers
4 x #8-32
Socket Head
Screws with
Washers