Filter
Top Products
Titler
48
The camcorder’s built-in titler can
store two different title pages in
memory. Each title page can be
displayed and recorded at any time.
The built-in character register
contains over 40 different characters
for creating titles with up to 32
characters on two lines.
Creating a Title
1. Attach a power source to the
camcorder, and slide the POWER
switch to the CAMERA position. Place
the ON/POWERSAVE lever in the ON
position.
2. Press the TITLER button to display the
title page graphics in the electronic
viewfinder.
Note: Press the TITLE SEL button to
display the other title page. Each time you
press this button, it will switch between the
two title pages.
3. Press the EDIT-ADV button to move
the flashing cursor to the place you
want to begin your title.
4. Select the first character for your title
by pressing the TITLE SEL + or TITLE
SEL
–
button until the character you
want appears. See the “Chart of
Characters” on the next page for the
characters available in the titler’s
register.
5. After you have selected the first
character, press the EDIT-ADV button
to move the flashing cursor to the
position where you want your next
character to appear.
6. Repeat steps 4 and 5 until you have
completed the title.
7. Press the TITLE SEL button if you
wish to create another title on the other
title page.
8. Press the TITLER button to store the
title and remove the title display from
the viewfinder when you are finished.
Important Note: Remember to remove the
titler graphics from the viewfinder for normal
recording.
REW
PLAY F. FWD STOP PAUSE
– TITLE SEL + EDIT-ADV
Button (Also Button)EDIT-ADV STOP
Button (Also Button)TITLE SEL+ F.FWD
Button (Also Button)TITLE SEL PLAY
Button (Also Button)TITLE SEL– REW
ButtonTITLER
FADE
RESET
DISPLAY
POWER
TITLE SEL
EDIT–ADV
REW
PLAY
F.FWD
STOP
PAUSE
OFF
VCR
CAMERA
EJECT
+
—
W
T
BATTERY
FULL AUTO
SHUTTER
DATE
TITLER
FOCUS
OFF ON
REVIEW