Filter
Top Products
EN - 9
Turning o the ash
1 Keep the ON/OFF button pressed for about 2 seconds to turn
o the ash.
Power saving mode
To save battery power, the ash unit will automatically enter
stand-by mode about 2 minutes after the camera's Auto Power
O is activated. In stand-by mode, the PILOT lamp blinks in red
every 2 seconds.
If you operate any of the buttons on the ash unit, or if the
camera is turned on, the ash will automatically wake up from
stand-by mode.
If the ash unit is left in stand-by mode for 30 minutes, the Auto
Power O function will be activated and the ash will be turned
o completely. To use the ash in such case, turn on the power of
the ash unit again.
* In slave mode the ash unit will not enter stand-by mode and
the Auto Power O function will be activated only after 60
minutes.