Filter
Top Products
EN - 13
* For details on the camera's settings, see the Camera User
Guide.
* In movie, dynamic range (DR), interval shooting, or M-Cont
Plus (HI) mode, the ash will not re.
Only with Type R cameras
With Type R cameras the ash output level can be changed on
the camera within the range 1/1 to 1/64.
1 Set the ash mode to NORMAL with the Mode select button
and the ash power level to Manual ash output adjustment
(the two rightmost ash power level indication lamps on) with
the Flash power level select button. Adjust the ash output
level while checking the image on the picture display on the
camera.
Perform the manual ash output level adjustment only after
the ash is attached to the camera.
Slave ash
This ash unit features a slave
ash function.
In slave ash mode, this ash
unit will re when it detects
the light from another ash.
The slave ash function is
especially eective in the
following situations.
When you do not want to
illuminate the subject from the front with the main ash light
source
When you want the this ash unit to re without having it
attached to the hot shoe
When the distance to the subject is too far and the ash
cannot reach the subject
When you want to add several ashes to an array
Caution
If the ash does not re, check the position and the angle of
the ash.
In slave ash mode, if the ash accidentally detects other
camera's ash, it may re before shooting. Check that the ash
unit is ready for another re by the PILOT lamp.
•
•
•
•
•
•
Camera's built-in ash
GF-1
Camera's built-in ash
GF-1