Filter
Top Products
12
Starting Your Camera
Press and hold the power On/Off button to start the camera. The LCD screen will light up and the camera
will sound a “beep”. This will confirm that your camera is on and ready for use.
Note: you can press
button repeatedly to enter or exit the menu in every mode.
Camera Mode
Set the mode dial to Camera Mode – the icon will appear on your LCD screen.
TAKING PHOTOS
You can compose your shot using either LCD screen. Hold the camera steady and press the shutter button to
take photo. There will be a short delay while the camera saves the photo to memory.
After each photo is shot (when the camera returns to icon mode) the numbers of photos left to shoot at this
resolution is displayed at the bottom right of the LCD screen.
When the camera's memory (photo capacity) is full, the LCD screen will display “0”. If you attempt to take a
photo when the memory is full, the camera will show “Memory Full, insert a SD memory card to transfer and
take more than two Test Photos” on the LCD screen.
NORMAL / MACRO SHOTS
The camera has a macro shot mode. To change slides in Normal/Macro shot mode, use the switch on the side
of the camera.
For close-up shots, the Macro Mode let you move in as close as 32.5 to 80 cm.
For normal shots, the Normal Mode let you take the extremely clear full view photos as 80 cm to the infinity.
Note: Flash-light will only work in normal shot mode.
DIGITAL ZOOM
You can magnify your subject up to 4 times using the digital zoom. Use the and buttons to adjust the zoom. The
icon will flash on your screen. Push the button to zoom in on your subject. Push the button to zoom back out.
DISPLAY