Filter
Top Products
13
The default display setting shows icons on the LCD screen. Press the Display Button once to switch off
the icons. Press the Display Button
again to switch off the LCD (to conserve battery power).
Pressing the
display button repeatedly to exchange between these display modes.
FLASH
In low light conditions it is best to use the built-in flash. You can also use the flash to compensate for backlight
conditions.
To set the flash:
1. Press the
button. The icon will appear on the LCD screen. This means the flash function has
been "forced on" (manual flash). If the flash is not ready, a red LED will light up above the LCD screen
and the
icon will flash repeatedly- wait until the flash is ready before taking a photo. A low battery
warning will appear on the LCD screen if there is insufficient battery power to operate the flash.
2. Press the
button repeatedly. Select the icon shown on the LCD screen. This will activate the
automatic flash.
3. Press the
button repeatedly until the icon appears. This will turn off the flash function.
SELF-TIMER
You can include yourself in a photo by using this feature to delay the time between your pressing the shutter
and when the photo is actually taken. It is recommended that you use a tripod when you use the self-timer.
1. Press the
button to select the
ON
icon shown on the LCD screen.
2. Press the shutter button to start a 10 second count down (the count down will appear on the LCD). After
10 seconds a photo is taken.
3. If date is selected the date and time the photo was taken will be recorded on the photo.
4. To set the date and time please refer to the Date and Time section in Setup Mode.
Date