Filter
Top Products
46_ main menu
main menu
SETTING THE DEVICE
You can configure the settings of: Camera, Storage Device, Remote Device and Monitor.
Camera
Setting the Camera
You can set Video, Audio, Channel Name and Dwell Time of a Camera.
Using the mouse may help make setup easier.
1. Press the [MENU] button on the remote control.
2. Use the left/right button (
_ +
) to select <Device>.
Device setting menu is selected.
3. Use the up/down buttons (
$%
) to move to <Camera>,
and press [ENTER] button.
4. Select <Camera>.
You will see a window where you can configure the
camera settings including Video, Audio, Channel Name,
SEQ-Dwell Time and Privacy Region.
5. Use direction buttons (
$%_ +
) to move to a desired
item, and set the value.
•Video
- <ON/OFF> : You can turn ON/OFF the selected channel’s
camera.
- <Covert1> : Shows information other than the video of
the selected channel.
`
For privacy protection, it does not display the video while the recording continues.
- <Covert2> : Shows nothing but an empty screen while the recording continues.
•Audio
- If set to <ON>, you can turn the audio of the channel ON on the Live screen.
- If set to <OFF>, the channel’s audio is off on the Live screen and not recorded.
•CH Name : Up to 15 characters including blanks are allowed.
`
Refer to “Using Virtual Keyboard”. (Page 37)
•SEQ-Dwell Time : You can set the dwell time between channels for the Live screen.
`
If set to <OFF>, the channel is not listed in the Auto Sequence mode.
Device
Logout
Return
Camera
Storage Device
Remote Device
Monitor
CH Video
Audio
CH Name SEQ-Dwell Time
1 ON
OFF
CAM 01 5 sec
2 ON
OFF
CAM 02 5 sec
3 ON
OFF
CAM 03 5 sec
4 ON
OFF
CAM 04 5 sec
5 ON
OFF
CAM 05 5 sec
6 ON
OFF
CAM 06 5 sec
7 ON
OFF
CAM 07 5 sec
8 ON
OFF
CAM 08 5 sec
Camera
Screen Setup
OK Cancel
Camera
Privacy Region