Filter
Top Products
50_ main menu
main menu
HDD Alarm
You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port,
and its duration.
Using the mouse may help make setup easier.
1. Use the up/down buttons (
$%
) in <Device> window to
move to <Storage Device>, and press [ENTER] button.
2. Select <HDD Alarm>.
A window for setting HDD check and replace output ports
and their durations appears.
3. Use direction buttons (
$%_ +
) to move to the desired
item.
•Alarm
- If <BEEP> was selected, a beep will sound.
•Check Alarm Output Port : If HDD generates check alarm,
the alarm signal will output to the specified alarm output port.
•Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified
alarm output port.
•Duration : Sets the alarm duration for the alarm signal and beep sound.
M
`
<Check> status means that the HDD is operating but it has problems that require technical examination.
(
) appears on the Live screen.
`
<Replace> status means that the HDD has defect and requires immediate replacement.
( ) appears on the Live screen.
4. When the HDD Alarm setup is done, press <OK>.
Remote Devices
You can set the Remote Control ID with the DVR.
Using the mouse may help make setup easier.
1. Use the up/down buttons (
$%
) in <Device> window to
move to <Remote Device>, and press [ENTER] button.
2. Use direction buttons (
$%_ +
) to move to the desired
item, and press [ENTER] button.
3. Make sure to match IDs of the DVR and Remote Control,
and press <OK>.
M
`
For changing the remote control’s ID, refer to “Changing the
Remote Control ID”. (Page 13)
Remote Control ON ID 0
Remote Device
OK Cancel
Storage Device
Format
OK Cancel
Device
HDD Alarm
Check Alarm Output Port
Duration OFF
BEEP
Replace Alarm Output Port
Duration OFF
BEEP