Filter
Top Products
If you set up the public DDNS (dyndns.
c
om, no-ip.com, or changeip.com), it will
take approximately 30 to 60 seconds
to get the IP address for the host name
(URL) to be updated in the DNS.
To connect this product to an IP
router, you have to designate a port
for this product in the setup menu of
the router. This product has 4 ports for
TCP communication. To use the DHCP
function provided by the IP router to
allocate the dynamic IP to the product,
designate a port for the IP that has
been allocated by the IP router setup
menu. When using the IP router, it
is recommended to use the fixed IP.
For that purpose, set the IP address
and port number to be allocated to
the product, select Static IP in the
connection mode and enter the IP
address assigned to the IP router. For
more information about using the IP
router, see the user manual of the IP
router or contact the manufacturer.
Callback Settings
This configuration is used to forward the callback
messages to the IP where Smart Viewer is
running. When any alarm, motion, or video loss
events occur, the system automatically connects
to the corresponding DVR to show the callback
messages.
On/Off: Off is default. To use the callback
function, choose On.
IP Address: Use the UP/DOWN direction
buttons to set the TCP IP address of the PC
where Smart Viewer is running.
Port(UDP): Use the UP/DOWN direction
buttons to set a port number ranging from
7900 to 7999. The number changes by 1. You
have to also set the port value in the Callback
Connection menu for Smart Viewer setup.
Retry: Select a number ranging from 1 to 20.
The number changes by 1.
Transfer Alarm In: Set it to On to display
alarms on Smart Viewer.
Transfer Motion Detection: Set it to On
to display motion detection events on Smart
Viewer.
Transfer Video Loss: Set it to On to display
video loss events on Smart Viewer.
Transfer System Log: Set it to On to display
system logs such as critical system failures.
CAUTION
Even if this function is set to On, any
callback message will not be created
unless the settings for alarm, motion
detection, and video loss are set in
Event Record.
To get the callback messages from
Smart Viewer, click Callback.
Transfer Picture Settings
You can configure the video size and quality for
transferring pictures.
Video Size: Select any of CIF and Half D1.
Quality: Select any of Very High, High,
Standard, and Low.
05 MENU SETUP
menu setup _33
On/Off On
IP Address 192.168.001.010
Port(UDP) 7900
Retry 05
Transfer Alarm In Off
Transfer Motion Detection Off
Transfer Video Loss Off
Transfer System Log Off
Callback Settings
Cancel
OK
Video Size CIF
Quality Very High
Transfer Picture Settings
Cancel
OK
SHR-5162_Eng.indb 33 2007-06-18 ｿﾀﾀ・11:48:33