Filter
Top Products
Smart Viewer _65
10 Smart Viewer
Remote Mode
This mode transfers the video data recorded on
DVR through the network for playback. Up to 4
channels are allowed for simultaneous search
and playback. The video data is played at the
position where the time bar is located.
When clicking this button, it changes to the
Remote mode.
Calendar Window
If the video data has been recorded on a date,
the date is distinguished in red. If you click the
date, the recorded video information is displayed
in the time line. If you select a date, it turns thick
red. Clicking
changes to the previous month
and clicking
changes to the next month.
Audio Volume, Video Brightness/
Contrast Buttons
Those buttons operate the same as the controls
in Monitoring Mode. The brightness and contrast
adjustment may not work depending on the
model.
Screen Split Selection Buttons
You can use any of full screen, single, quad
(4-split), 9-split, and 16-split modes.
In the Remote mode, 9-split mode is not
available while in the Local mode, quad
and 9-split modes are not available.
Video Save (Backup)/Video
Conversion/Print/Setup
1
2
3 4
1. Video Save button
During playback (play/reverse play/fast
forward/fast backward), if you select a
channel and click this button, the video
data is saved in a DVR file. (It is saved in the
designated folder on your PC.)
The directory, file naming convention, and
recording time can be configured in Viewer
Setup for Setup Mode. You can set the
recording duration ranging from one minute
to 10 minutes. To stop recording, click this
button again. But this action is possible in 10
seconds after the recording starts.
If the video file is not playing, this button
e
nables you to perform backup, which brings
up the following window.
You can set the starting and ending times for
backup and select a file format for saving.
Clicking Start begins the backup process.
The backup file is saved in the folder which
was defined by Setup > Viewer Setup >
Video Recording > Video Location.
To stop the backup process, click Stop.
This function is enabled only when the
playback actions are in progress.
SHR-5162_Eng.indb 65 2007-06-18 ｿﾀﾀ・11:50:21