Filter
Top Products
Name and Function of Each Section
COLOR DOME CAMERACOLOR DOME CAMERA User’s ManualUser’s Manual
1312
Installation
Installation
• The installation should be done by qualified service personnel or sysytem installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
Notes
Locking
direction
(Clockwise)
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Latch
Locking direction
[Figure-1]
Pan Base Holding Screws (Color : Silver)
fix panned position
Zoom Handle
adjust zoom between WIDE and TELE
Focus Handle
after adjusting zoom, adjust focus
SETUP button
Used for the menu display. Confirm the status of the selected function.
Left button Right button
Used when changing item values, by moving the cursor to the left or right on the
menu screen
Up button Down button
Used when changing item values, by moving the cursor to the up or down on the
menu screen
Service connector for on-site camera set-up
A terminal can be connected to an LCD
monitor, allowing the operator to easily
adjust the camera angle within the monitoring
range during its installation.
Power input jack
Video output jack
Shield Case
Dome cover
Service/ Monitor Cable
External Viewer (not supplied)
1) Remove the dome cover and shield case from the main body by loosening the
three dome cover screws.
2) And then remove the main body from mounting bracket by the four main body screws.
Mounting Bracket
Main Body (Camera)
Shield Case
Dome cover
Unlocking direction
(Counterclockwise)