Filter
Top Products
COLOR DOME CAMERACOLOR DOME CAMERA User’s ManualUser’s Manual
1514
Camera
body
Unlocking
direction
M4 tapping screw
(provided)
Dome cover
adapter plate
An arrow for installing directions
1) Place the bracket provided on the installation
surface and fix it with the M4 tapping
screws (provided).(Select either 85X85 or
83.5X46)
2) When placing the camera body on the
plate, insert the plate pin into the
mounting hole on the body as shown in
figure-1 and fix it by turning clockwise.
3) When placing the camera body on the
plate, make sure the power and the BNC
cables pass through their respective
designated holes.(When placing the cable
through its side, thread it through the
hole at the bottom.)
4) After installation and adjustment of the
camera are complete, secure the dome
cover by turning it clockwise.
When installing on a adapter plate
Installation
Locking
direction
[Figure-1]
Locking
direction
Plate pin
Unlocking
direction
• Please locate an arrow on bracket for installing direction that you wish to
observe Area and then fix it with the M4 tapping screws.
Notes
•
When installing SID-452 be careful in setting lens focus and Tilt angle. If you set the lens focus max
WIDE(f=3.0mm) and Tilt angle over 68˚, some portion of image will be screened by Dome cover.
Notes
Adjust the panning and tilting, rotating while watching the monitor
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170˚ to each side direction and 340˚ on the whole.
• Tilt Base covers total 146˚ angle(73˚ to each side).
• Angle range of Rotate Base is the same as that of Pan Base. But One side range is 195˚
and another is 145˚.
2) Methods of adjustment
•The case of wall installation
After mounting the camera on a wall, adjusting the panning angle so that the camera can
face the direction to monitor when tilting.
And then adjust the tilting angle by rotating the tilt base.
Loosen the rotate base hold screw and adjust rotate base for the best monitoring.
Tighten the rotate base hold screw.
•The case of ceiling installation
After mounting the camera on a ceiling, adjusting the panning angle for better monitoring
area by rotating the pan base.
And then adjust the tilting angle by rotating the tilt base.
73˚
-170˚
145˚ 195˚
170˚
Pan Base
Tilt Base
Rotate Base