Samsung SNB-3000(P) Security Camera User Manual


 
setup screen
52_ setup screen
MAC address : Displays the Ethernet MAC address.
This is used for creating a DDNS address.
IP address : Displays the current IP address.
Subnet mask : Displays the <Subnet mask> for the set IP.
Gateway : Displays the <Gateway> for the set IP.
DNS server : Displays the DNS(Domain Name Service) server address.
HTTP webserver port : HTTP port used to access the camera via the web
browser. The default is 80(TCP).
Upload port (TCP) : Used to upgrade the software firmware, defaulted to 60004(TCP).
IPv6 configuration : Obtains the IPv6 address to access the IPv6 network.
VNP configuration : Set a port used to transfer video signals with the Samsung
protocols.
Device port (TCP) : Used to control the video signal transfer, defaulted to 60001(TCP)
.
TCP streaming port : Video signal transfer port using TCP protocols, defaulted
to 60002(TCP).
UDP streaming port : UDP Port used to transfer video signal with the UDP
Unicast protocols. The default is 60003(UDP).
Multicast address : IP address used to transfer video signal with the UDP
Multicast protocols.
The default is 225.128.1.128, and if you want to change the address, specify it
ranging from 224.0.0.0 to 239.255.255.255.
Multicast port : UDP Port used to transfer video signal with the UDP Multicast
protocols. The default is 60005(UDP).
TTL* : Set the TTL for the VNP packet.
The default is 63, and if you want to change the address, specify it ranging from
0 to 255.
RTP configuration : You can set the RTP protocol.
RTSP port : You can set the RTSP port.
Streaming port : Used to transfer video signal with the RTP protocols.
The default range is between 61000 and 61999.
Multicast address : IP address used to transfer video signal with the RTP
protocols.
Multicast port : Used to transfer video signal with the RTP-protocol multicasting.
TTL* : You can set the TTL for the RTP packet.
When done, click [Apply].
Your settings are saved and the system restarts.
The currently opened web browser will be closed.
If the IP router has more than one camera connected, you should configure IP and port settings
differently with each other.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
2.
M