Filter
Top Products
setup screen
64_ setup screen
Set rules
You can set the event rules.
Virtual line based rules : You can configure event rules for up to 3 virtual lines.
<Event Types>
Pass : Event is generated if a moving object crosses the virtual line in the specified
direction (
,
,
)
Defined area based rules : You can configure event rules for up to 3 user-
defined areas.
<Event Types>
Entering : Event is generated if a moving object enters the defined area from
outside to inside.
Exiting : Event is generated if a moving object exits the defined area from
inside to outside.
Appearing : An object that has not been existed in the area until the previous
frame suddenly appears inside the configured area, not passing the border
Disappearing : An object that has been existed in the area until the previous
frame suddenly disappears, not passing the border.
Entire area based rules : You can configure event rules for the entire video area.
<Event Types>
Appearing: An object that has not been existed until the previous frame
appears in the area.
Disappearing: An object that has been existed until the previous frame
disappears from the area.
Scene Change: This event is generated by a complete scene change, such as
camera veiled by hand or changed camera’s aiming, etc.
Object size: The maximum object size of motion detection for each event
generation. The minimum size can be adjusted in 5 levels.
Minimum size (the minimum rectangular motion detection area): Step 1: 6x6 (pixel),
Step 5: 50x50 (pixel)
Maximum size (the maximum rectangular motion detection area): Step 1: 60x60
(pixel), Step 5: 320x240 (pixel)
The initial setup for the minimum is 6x6 and for the maximum is 320x240.
-
-
-
-