33_ English
臺灣
_33
DVD camcorder mode:
recording/playback
RECORDING MOVIE IMAGES
• You should set the Storage mode switch to
DISC before recording on a disc.(VP-DX103(i)/
DX104/DX105(i) only)
page 30
• You can record movie images using the
remote control. (VP-DX102/DX104/DX105(i) )
page 13
• This DVD camcorder provides two Recording
start/stop buttons. One is on the rear side of the
camcorder and the other is on the LCD panel.
Select the Recording start/stop button that
works best for you.
1. Turn the DVD camcorder on.
• Connect a power source to the DVD
camcorder.
(A battery pack or an AC power adaptor)
• Slide the POWER switch downwards to turn
the DVD camcorder on.
• Set the Storage mode switch to DISC. (VP-
DX103(i)/DX104/DX105(i) only)
page 30
2. Check the subject on the LCD screen. (Lens
and LCD)
• Set the Lens open/close switch to open
( ).
page 10
3. Press the Recording start/stop button.
• The
(
) recording indicator will display, and
recording will start.
• Press the Recording start/stop button
again to stop recording.
4. When recording is fi nished, turn the DVD camcorder off.
DVD
攝錄放影機模式:
錄製 / 播放
錄製影片影像
• 在光碟上進行錄製之前,您應將
儲存模式
開
關設定為
DISC
。(僅適用於 VP-DX103(i)/
DX104/DX105(i))
第 30 頁
• 您可以使用遙控器錄製影片影像。(僅適用於
VP-DX102/DX104/DX105(i))
第 13 頁
• 此 DVD 攝錄放影機具有兩個
錄製開始 / 停止
按鈕。其中一個位於攝錄放影機背面,另一
個位於 LCD 面板上。選擇
錄製開始 / 停止
按
鈕(具有最佳工作效果)。
1.
開啟 DVD 攝錄放影機。
• 將電源連接到 DVD 攝錄放影機。
(電池組或交流電源適配器)
• 向下滑動
POWER
開關以開啟 DVD 攝
錄放影機。
• 將
儲存模式
開關設定為
DISC
。(僅適用
於 VP-DX103(i)/DX104/DX105(i))
第 30 頁
2.
檢查 LCD 螢幕上的主體。(鏡頭和 LCD)
• 設定
鏡頭開啟 / 關閉
開關以開啟 ( )。
第 10 頁
3.
按下
錄製開始 / 停止
按鈕。
• (
) 錄製指示器將會顯示,並且錄製將
會開始。
• 再次按下
錄製開始 / 停止
按鈕以停止
錄製。
4.
在完成錄製時,關閉 DVD 攝錄放影機。
0:00:00 [30 min]
STBY 0:00:00 [30 min]
Eng+Tai_VP.indb 33 2008-03-07 ¿ÀÈÄ 6:22:48