Filter
Top Products
SETTING THE DATE AND TIME
The digital camera will record the date and time an image or audio recording is taken so that you
can display them during playback. Therefore, before capturing images, make sure the correct
date and time are set.
Example: To set the clock to August 28, 2001 at 7:30 p.m.
1 Display the Shooting Option Setting Screen (or
Playback Option Setting Screen) (see page 29).
2 Press l button on the arrow button to select
“CLOCK SET”, and then press the SET button.
The CLOCK SET menu appears.
The current date and time settings appear.
Follow the procedures below to set whether to
display the date during playback, to set the date
and time, and to set the display format for the date.
To return to the Option Setting Screens, press the
MODE button, or select “EXIT” and press the SET
button.
NOTE
If the date and time are not set, January 1, 2000 midnight is recorded as the date and time.
Consequently, “2000/01/01 00:00” appears during playback.
Under normal conditions, while the batteries are replaced, an internal battery will maintain the
date and time settings. However, there is a small chance the settings may be lost. (The backup
will last for approx. 30 minutes.) It is recommended to check that the date and time settings are
still correct after replacing the batteries and before shooting or recording of any type (follow
steps 1 and 2).
Main switch
Selector dial
MODE button
Arrow button
LCD monitor
SET button
AUDIO REC
CLOCK SET
BEEP
DISCHARGE
LANGUAGE
REFORMAT
41 English